ECS P965T-A Motherboard
ABIT AN8 SLI Motherboard
Foxconn 975X7AB-8EKRS2H Motherboard
Foxconn BlackOps Motherboard
The Missing Post Mystery
A post I made to a Vista newsgroup was missing from the Outlook newsreader
Where did it go?
The Missing Post Mystery Revisited
It happened again! A post I made to a Vista newsgroup was missing from the Vista Mail newsreader
Where did it go?
A Case of Maxtaken Identity
When is a hard drive not a hard drive? Find out when!
Vista Image Capture 'Slipstream' SP1 and SP2 into a single Vista install disc
Detailed Instructions for Reverse Integrating SP1 and SP2 into Vista
Ten things you can do to create better documentation
Flash Your BIOS
Three Good Reasons for Flashing Your BIOS
Ten common mistakes you should avoid when flashing your BIOS
Find a new dial-up ISP
Sign up for 10 free hours of NetZero access!
What is a computer guy doing with home remodeling projects on his Website?
Playing the Rebate Game
Know the Rules Before You Play
The four questions you need to ask before buying Vista
Click on thumbnail to see a larger image
|I had removed a section of wallboard in order to to fix a leak from the hot water supply line. I traced the section below the valve but didn't need to remove it to get the pipe fixed.||I used a wood chisel to chisel out two sections where two four inch wide pieces of scrap wood flooring would go.|
|Liquid Nails was used to attach the right side of the backing to the studs. Liquid Nails was put on the front of the left side of the wood pieces and attached to the back of the wallboard. The adhesive was allowed to dry overnight.||I had the original piece of wallboard that was cut out. I put enough Liquid Nails to cover the back of the piece of wallboard where it would make contact with the wood pieces and set it into place. After drying, the wall was ready to be covered with ceramic tile.|